Installation of Deadbolt Instructions For Homeowners: A Deadly Simple Guide
Do you want to know how to keep your family and home safe? Installing a deadbolt is a great way to keep your home safe. To save money on deadbolt installation, some homeowners are willing to take on the project themselves. Others might rather enlist the help of an expert. Lock change is also essential part of home security.
If you’re interested in learning more about how the process works, check out our step-by-step guide on installing a lock below .
Refer to the manufacturer’s instructions for the first step.
No matter what sort of deadbolt you buy, our tutorial should provide you with a full overview of how to install it at home. However, for your specific product, you must always follow the manufacturer’s directions.
When you purchase a lock, the manufacturer will usually include a thorough template to assist you with installation. This template is suitable for doors of various thicknesses, and it includes reference points that may be marked with a little pointed tool.
Drill a Deadbolt Hole
A deadbolt lock should always be installed 6 to 12 inches above the doorknob. Begin by using your hole saw to make the hole for your deadbolt with a pilot bit attached.
When the bit comes through the other side of your door, stop cutting. To avoid being cut by splintered wood, you might fill the hole from the opposite side.
Drill a hole through the door’s edge
In a standard drill, insert a 7/8′′ spade bit. Make a hole in the door’s edge with a drill. This is the location where the bolt will be inserted.
Connect the Area Surrounding the Faceplate to the Area Surrounding the Faceplate.
Place your deadbolt in the newly drilled hole. Use a wood chisel to convert the region into a four-sided hole that will fit the tenon and make the faceplate flush with the door.
Make sure the bevelled side of the chisel is facing the mortised region as you work with it. Because mortising the non-rectangular corners is tough, you may need to use a smaller chisel.
Tighten the door latch.
Keep using the chisel to make your four-sided hole. Continue working on the faceplate until it fits precisely.
The bolt can then be secured to the door by drilling pilot holes and screwing it in place.
Install the thumb lever and cylinder
Run a test to see how the thumb-turn plate and cylinder fit together.
The exterior side of the door can now be installed. After that, position the inside piece.
Screw the deadbolt into place after aligning the mounting holes and screw holes.
Bind the Faceplate and Drill Holes
Close the door and use a marker to indicate the deadbolt’s end. To make a mark on the doorframe, turn the deadbolt a couple of times.
Use the spade bit from before to make two overlapping holes in your door’s frame.
You’ll need to mortise the area once more in order for the strike plate to seat correctly.
Drill pilot holes and screw the striker plate into place to finish the project.
Which is better for me: do-it-yourself or hire a pro?
Go ahead and attempt these steps if you believe you are capable of doing so. To learn the procedure, you only need the proper tools and a little patience. Also, don’t rush the installation; misaligning items or drilling holes incorrectly can result in additional effort that you weren’t expecting.
Keep in mind that deadbolt installation is a complicated process, and some homeowners prefer to use a professional. For skilled deadbolt installation for your property, call our Locksmith Near Me at Best Locksmith.
